How To Create Sub Interface On Router. Like so, network > interfaces > {physical interface} > create new > interface. The router needs access to both vlans so the link between the router and switch will be a trunk!
Yes there is something else that you need to configure under the t1 controller to create the serial interface. So i needed to create two sub interfaces on the fortigate (on port3). And this should create the serial interface.
The syntax for the subinterface is the. Like so, network > interfaces > {physical interface} > create new > interface. A subinterface is a virtual interface created by dividing one physical interface into multiple logical interfaces.
So I Needed To Create Two Sub Interfaces On The Fortigate (On Port3).
This additional information is helpful. To configure ip over vlan over an ethernet interface: The period in front of the subinterface value is required as part of. If we have one router with one physical interface, but needed to have the router. To configure layer 3 subinterfaces:
And This Should Create The Serial Interface.
A subinterface is a virtual interface created by dividing one physical interface into multiple logical interfaces. The syntax for the subinterface is the. 2 different vlans have been created on the switch. Simply put, on a fortigate if you want what a cisco engineer would refer to as a ‘sub interface‘, then you simply add a vlan interface to a physical interface. Physical interface or virtual interface followed by the subinterface path id.
Simply put, on a fortigate if you want what a cisco engineer would refer to as a ‘sub interface‘, then you simply add a vlan interface to a physical interface. If you do need to use switchport mode, you need to create a vlan, allow it on the required interfaces and configure the ip address on an svi instead of an l3 subinterface. Creating sub interface(s), adding them to vr and adding static route to the vr:
Each Subinterface Is Created Using The Interface Interface_Id Subinterface_Id Global Configuration Mode Command.
Like so, network > interfaces > {physical interface} > create new > interface. To configure layer 3 subinterfaces: Simply put, on a fortigate if you want what a cisco engineer would refer to as a ‘sub interface‘, then you simply add a vlan interface to a physical interface. Yes there is something else that you need to configure under the t1 controller to create the serial interface. To know more about what is a subinterface in a cisco router, keep.
For Examples, See Configuring Vlan Subinterfaces, Next.
So i needed to create two sub interfaces on the fortigate (on port3). To configure ip over vlan over an ethernet interface: Creating sub interface(s), adding them to vr and adding static route to the vr: 2 different vlans have been created on the switch. The figure shows that multiple subinterfaces are configured.
